®
Outdoor Patio Heater
Wheel Assembly Kit
Hardware
Component
A
B
C
Wheel Bolt
2 pcs
2 pcs
2 pcs
5/16” - 18 x 15 Stainless Steel Hex Head Bolt
Wheel Nut
5/16” - 18 Stainless Steel Hex Nut
Wheel Washer
8 mm Stainless Steel Washer
1. Wheel Assembly . . . . . . . . . . . . . . . . . . . . . 56-01-378
Attach wheel assembly during heater assembly
Step
Note: Attach wheel assembly to base prior to attaching the weight plate.
A. Attach wheel assembly to base using 2 sets of wheel bolts (A), wheel washers (C) and wheel nuts (B).
B. Continue heater assembly in Owner’s Manual.
1
Attach wheel assembly after heater is assembled
A. Lay heater on its side. Be careful not to damage your dome. Support the post on a box or other sturdy item.
B. Remove weight plate, if needed.
C. Attach wheel assembly to base using 2 sets of wheel bolts (A), wheel washers (C) and wheel nuts (B).
D. Reassemble weight plate, if removed.
E. Stand heater upright.
A
C
B
Manufactured in China for:
Blue Rhino Global Sourcing, LLC
104 Cambridge Plaza Drive, Winston-Salem, NC 27104 USA
© 2005 Blue Rhino Global Sourcing, LLC. All Rights Reserved
Endless Summer® is a Registered Trademark of Blue Rhino Global Sourcing, LLC. All Rights Reserved
WK-INS-100 E
|
Blanco Indoor Furnishings 157 095 User Manual
Bowers Wilkins Speaker DM6025 S3 User Manual
Breville Mixer BFP250 User Manual
Briggs Stratton Water Dispenser 290000 User Manual
Brunton Battery Charger 15W 12V User Manual
Canon Camcorder 500 HS User Manual
Casio Projector XJH2650 User Manual
Chamberlain Garage Door Opener 1145 1 3HP User Manual
Chauvet Marine Lighting FC T User Manual
Cisco Systems IP Phone 7942G User Manual